Safety and care

A few simple habits keep your Clearwake Spin Scraper working well for many winters.

about 3 hours to a full charge
USB-C
of use per charge, roughly
40 min
windshields, windows, mirrors
Glass only

Charging

  • Charge with a USB-C cable and a standard USB charger, laptop or car USB port.
  • Charge indoors at room temperature. If it has been out in the cold, let it warm up for 30 minutes before charging.
  • Don't charge it while it is wet. Dry it with a cloth first.
  • A full charge takes about 3 hours. Unplug it when it is full.

Using it in the cold

  • Cold shortens the run time of any battery. Keep the scraper in the cabin or door pocket, not in the trunk.
  • Hold it flat against the glass and let the spinning blades do the work. Pressing hard does not clear faster.
  • Keep fingers, hair and loose clothing away from the spinning disc.

Glass only

  • Use it on windshields, windows and mirrors only.
  • Keep it off paintwork, plastic trim, rubber seals and wiper blades.

Thick ice and glaze

It is made for frost and thin ice. After freezing rain or on a thick glaze, run your defroster for a few minutes first, then clear what is left. Never use it to chip or hammer at ice.

Storing it

  • Store it charged. Between winters, top up the charge every 2-3 months.
  • Over summer, store it somewhere cool and dry, not in a hot car.
  • Do not immerse it in water.

Battery safety

  • Stop using it and contact us if it gets very hot, swells, leaks or smells unusual.
  • Do not open the case or try to replace the battery yourself.
  • Keep it away from children. It is not a toy.
  • At the end of its life, recycle it at a battery collection point, not in household trash.

Questions? Email . Faults in the first year are covered by our 1-year warranty.